Motorola CAJUN P880 - Manual (Page 24)

1 - 14 Cajun P880 Routing Switch Installation Guide
1
6. Push the ejectors into the closed position to complete seating the
module (Figure 8).
Figure 8. Closing the Ejector Tabs
7. Tighten the captive screws.
CAUTION
■
Ensure that all adjacent modules are seated and the
captive screws secured. Failure to do this may result in
difficulty installing other modules into the chassis.
■
Ensure that all unused module slots have a filler panel
installed to maintain EMI integrity.
Installing the Cables
Install appropriate cables for your network configuration. P880
Cajun switch cable types include:
■
Fiber cables with SC-type connectors
■
Straight-through Category 5 cables with male RJ-45
connectors (end station/NIC (network interface card) card
connections). All I/O ports are crossed over internally so you
can use straight-through cables to attach to end stations.
■
Crossover cables with male RJ-45 connectors (switch-to-
switch connections).
The types of cable for the ethernet console (out-of-band) are
different. Refer to Chapter 2, “Configuring the Cajun Switch (Layer
2 & Layer 3),” for more information.