Before using, Equipment mains working setting, Copyright – Marantz SM-1151 User Manual

Page 9: Inappropriate places for installation

Advertising
background image

3

ENGLISH

BEFORE USING

This section must be read before any connection is made to
the mains supply.

EQUIPMENT MAINS WORKING
SETTING

Your Marantz product has been prepared to comply with the
household power and safety requirements that exist in your area.

— Power requirements (U.S.A.) ....................AC 120V 60Hz
— Power requirements (Europe) ..............AC 230V 50/60Hz

COPYRIGHT

Recording and playback of any material may require consent.
For further information refer to the following:

— Copyright Act 1956

— Dramatic and Musical Performers Act 1958

— Performers Protection Acts 1963 and 1972

— Any subsequent statutory enactments and orders

INAPPROPRIATE PLACES FOR
INSTALLATION

To keep your player in perfect working order for the longest possible
time, avoid installing the player in the following locations.

• Wherever it will be exposed to direct sunlight

• Wherever it will be close to a heater or other heat-radiating

appliance

• Wherever the humidity is high or ventilation is poor

• Wherever it is very dusty

• Wherever it will be subject to vibration

• On top of a rickety stand or in an unstable location which is

tilted at an angle

• In an audio rack with little space at the top and bottom or other

location where the heat dissipation will be obstructed

To ensure proper heat dissipation, install the player while

leaving clearances between the player and wall or other
components, as shown in the figure below.

DISPLAY

DISPLAY

POWER ON/OFF

POWER ON/OFF

METER

METER
MODE

MODE

BALANCED

BALANCED

UN-

UN-

BALANCED

BALANCED

SPEAKERS

SPEAKERS

1

SPEAKERS

SPEAKERS

2

STANDBY

STANDBY

0.2 m (8 ins.)
or more

0.2 m (8 ins.) or more

0.2 m (8 ins.)

or more

0.2 m (8 ins.) or more

7

Do not place objects on top

• Refrain from placing any objects on top of the player.

7

Cautions on handling power cord

• Do not touch the power cord with wet hands.

• When disconnecting the power cord, always make sure that

you take hold of the plug. Yanking out or bending the cord
can damage it and/or cause electric shocks or a fire.

• Get into the habit of disconnecting the power plug before

leaving home.

7

Do not touch hot spots during and

Immediately After Use

During and immediately after use, the unit is hot in areas other
than the controls and rear panel connection jacks. Do not touch
hot spots and especially the top panel. Contact with hot areas
can cause burns.

Advertising