Fade-in/out, Sync recording – Marantz CDR632 User Manual

Page 27

Advertising
background image

5 – Recording—Fade-in/out

27

ENGLISH

Fade-in/out

When recording, you can fade-in the input signal
from silence to the specified level, or fade-out from
the current level to silence. The fade-in/out times can
be specified independently.

1

As described in “Basic operation in Menu
mode” (

p.12), access the

“FADE IN?”

menu item and press the ENTER button.

The display will indicate “Fade In> XXs” (you
can select 1–30).
Here you can specify the fade-in time.

2

Turn the MULTI JOG dial to specify the fade-
in time.

3

Press the MENU button to return from menu
mode to normal mode.

By selecting the “FADE OUT?” menu item in
step 1, you can specify the fade-out time in the
same way.

4

To execute a fade-in, press the FADER but-
ton on the front panel (or the remote control
unit) from record-ready mode.

Recording will begin at the same time as the fade-
in, and the display will indicate “Fade In”.

5

To execute a fade-out, press the FADER but-
ton on the front panel (or the remote control
unit) during recording.

The fade-out will begin, and recording will stop
when the fade reaches silence. The display will
indicate “Fade Out” while the fade-out is occur-
ring.

Note

You are able to operate fade-out during a fade-in, or fade-
in during a fade-out.

Sync recording

Sync recording makes recording begin automatically
when the input signal exceeds a specified level (the
sync level) and end automatically when silence is
detected at the end.

1

After entering record-ready mode (

p.25), press the SYNC REC button repeat-
edly to select

“Sync ALL”

or

“Sync 1”

.

Each time you press the button, the display will
cycle through the following settings: “Sync ALL”
(repeatedly sync-record the input source)

“Sync 1” (sync-record only once)

→ “Sync

OFF” (sync-record is off).
If “Sync ALL” is selected, the [SYNC] indicator
in the display will light, and the CDR632 will be
ready to sync-record.
If “Sync 1” is selected, the [SYNC] indicator in
the display will blink, and the CDR632 will be
ready to sync-record.

2

If necessary, you can adjust the sync level
as follows.

1

As described in “Basic operation in Menu
mode” (

p.12), access the “SYNC

LEVEL?” menu item and press the MULTI
JOG dial.
The display will indicate “S_LEV> XXXdB”.

2

Turn the MULTI JOG dial to set the sync
level. The range is –24 dB to –72 dB (6 dB
steps).

3

Press the MENU button or ENTER button
to exit menu mode.

FADER button

1, 4

2

Advertising