Genuine miller, Accessories, Water-cooled tig torch adapters – Miller Electric Coolmate 4 User Manual
Page 4: Water hoses and connectors, Coolants, Replacement filter assemblies
4
Water-Cooled TIG Torch Adapters
50-mm Dinse with Water Return Line
#195 377
For Maxstar 200 and 350, Dynasty 200
and 350, and Syncrowave 250 and 350.
Used with (WP125, WP24W, WP25, WP20,
WP18, WP12, CS310, CS410, WP22,
WP27) water-cooled torch.
50-mm Dinse Flow Thru #195 380
For Syncrowave 200. Used with (WP125,
WP24W, WP25, WP20) water-cooled torch.
50-mm Thread Lock Style #225 028
For Dynasty 700 and Maxstar 700. Used
with (WP125, WP24W, WP25, WP20,
WP18, WP12, CS310, CS410, WP22, WP27)
water-cooled torch.
Water-Cooled TIG
Block Adapter #45V11
For Miller power
sources with stud-type
output terminals.
Replacement Water Hose for Dinse Adapter
#222 809 18 in. (457 mm)
Water Hoses and Connectors
Water Hose Extension
#40V76R6 6 ft. (1.8 m)
Hose with two male 5/8-inch 18 LH thread
connections.
Water Coupler #057 020
Brass hose fitting with 5/8-inch 18 LH
thread.
Coolants
Sold in multiples of four in 1-gallon
recyclable plastic bottles. Miller coolants
contain a base of ethylene glycol and
deionized water to protect against freezing
to -37° Fahrenheit (-38° C) or boiling to
227° Fahrenheit (108° C).
Low-Conductivity Coolant
(Clear, Pre-Mixed) #043 810
For TIG and MIG applications. NOT for use
in push-pull systems or systems where
aluminum is in coolant path/circuit.
Aluminum-Protecting Coolant
(Green, Pre-Mixed) #043 809
Primarily used in push-pull systems where
aluminum is in coolant path/circuit and
high frequency is NOT used.
Replacement Filter Assemblies
Filter Assemblies
#166 564
For Coolmate 1, 3 and 3X
#215 667
For Coolmate 3.5
Filter Strainer
#146 249
For Coolmate 4
Located inside pump assembly.
See owner’s manual.
Genuine Miller
®
Accessories
#166 564
Filter
#215 667
Filter
With gas and
water return
line.