Marantz MM9360 - Manual (Page 9)

9
anced connections, and try moving the amplifier, wiring,
lighting, or other equipment to different locations to isolate
the source of the noise.
9. SPECIFICATIONS
*Power Output
(Maximum Average Power, 0.1% THD, 1KHz)
Rated Per Channel, Two Channels Driven
MM9360 MM9340
4 ohm: 250W RMS 400W RMS
8 ohm: 150W RMS 275W RMS
Mono Bridged
(1 Channel)
8 ohm:
500W RMS 800W RMS
Rated Per Channel, All Channels Driven
MM9360 MM9340
4 ohm: 250W RMS† 400W RMS†
8 ohm: 150W RMS 275W RMS
Mono Bridged
8 ohm:
500W RMS 800Watts RMS
Input Impedance: 20K ohm balanced, 10K ohm unbalanced,
3.65K ohm RCA
**THD ( Full Power 1KHz @ 8 ohms): < 0.06%
**THD (20Hz-20KHz @ 8 ohms): < 0.2%
**IMD
(SMPTE 60Hz/7KHz 4:1)
@ 8 ohms: <0.2% (throughout power range)
(IHF) @ 8 ohms: <0.1% (throughout power range)
**Hum and Noise: -100dB from full output (A-weighted)
Full Power Input Sensitivity:
MM9360 MM9340
1.08V RMS (2.9dBu) 1.47V RMS (5.6dBu)
Frequency Response:
8 ohm: ±0.5dB 20Hz-20kHz
4 ohm: ±1.5dB 20Hz-20kHz
Voltage Gain: 32X (30.1dB)
Crosstalk: < -80dB (20Hz - 1KHz)
Signal Present Signal Sensitivity: 13mV RMS (-35.5dBu)
Power Requirement: 110-125VAC 50/60Hz
Typical Idle Current
MM9360 MM9340
120V: 0.81A 120V: 0.9A
Current with Typical Audio Program Material (4 ohm load -
all Channels)
MM9360 MM9340
120V: 6.5A 120V: 7.0A
Connections
Input: XLR - 1/4” (Pin 2: Hot, Tip: Hot), RCA
Output: 5-Way Binding Post
Cooling: Forced Air, Thermal Sensitive Variable Speed Fan,
Front Inlet/Rear Outlet
Dimensions: 17 5/16” W x 5 3/4” H x 13 1/8” D
Construction: 14 Gauge All-Steel Chassis, Aluminum Front
Panel
Weight: MM9360 MM9340
Shipping 51lbs. 50lbs.
Net 45lbs. 44lbs.
Specification conditions: 120VAC 60Hz, 25°C
* Continuous power limited by power line capacity
**Non-conventional amplifiers require bandwidth limiting for
all distortion and noise measurements.
† Signal peaks in audio programming may trigger protection
circuitry at low line voltages. Specifications are subject to
change or improvement without notice.