Troubleshooting – Maytag 750 User Manual

Page 26

Advertising
background image

25

Oven door will not unlock after

• Oven interior is still hot. Allow about one hour for the oven to cool after the

self-clean cycle.

completion of a self-clean cycle. The door can be opened when “Lock” is not
displayed.

• The control and door may be locked. See page 9.

Smoothtop surface shows

1. Tiny scratches or abrasions.

wear.

• Make sure cooktop and pan bottom are clean. Do not slide glass or metal pans

across top. Make sure pan bottom is not rough. Use the recommended
cleaning agents. See page 20.

2. Metal marks.

• Do not slide metal pans across top. When cool, clean with Cooktop

Cleaning Creme. See page 20.

3. Brown streaks and specks.

• Remove spills promptly. Never wipe with a soiled cloth or sponge. Make sure

cooktop and pan bottom are clean.

4. Areas with a metallic sheen.

• Mineral deposits from water and food. Use recommended cleaning agents.

See page 20.

5. Pitting or flaking.

• Remove sugary boilovers promptly. See page 20.

Moisture collects on oven

• This is normal when cooking foods high in moisture.

window or steam comes from

• Excessive moisture was used when cleaning the window.

oven vent.

There is a strong odor or light

This is normal for a new range and will disappear after a few uses. Initiating a clean

smoke when oven is turned on.

cycle will “burn off” the odors more quickly.

• Turning on a ventilation fan will help remove the smoke and/or odor.
• Excessive food soils on the oven bottom. Use a self-clean cycle.

Fault Codes

• “Bake” or “Lock” may flash rapidly in the display to alert you if there is an error

or a problem. If “Bake” or “Lock” appear in the display, press CANCEL pad.
If “Bake” or “Lock” continue to flash, disconnect power to the appliance.
Wait a few minutes, and then reconnect power. If the flashing still continues,
disconnect power to the appliance and call an authorized servicer.

• If the oven is heavily soiled, excessive flareups may result in a fault code during

cleaning. Press the CANCEL pad and allow the oven to cool completely, wipe out
excess soil, then reset the clean cycle. If the fault code reappears, contact an
authorized servicer.

Noises may be heard.

• The oven makes several low level noises. You may hear the oven relays as they go on

and off. This is normal.

• As the oven heats and cools, you may hear sounds of metal parts expanding and

contracting. This is normal and will not damage your appliance.

There are no beeps and

• Oven may be in Sabbath Mode. See page 14.

no display.

PROBLEM

SOLUTION

Troubleshooting

Advertising