Moxa Technologies NPort 5400 - Manual (Page 50)

NPort 5400 Series User’s Manual Web Console Configuration
5-25
Reverse Telnet Mode
TCP alive check time
Setting Factory Default Necessity
0 to 99 min 0 Optional
Specifies the time slice for checking if the TCP connection is alive. If no response, NPort 5400 series
will disconnect the original connection.
Inactivity time
Setting Factory Default Necessity
0 to 65535 ms 0 Optional
Idle time setting for auto-disconnection. 0 min. means it will never disconnect.
Local TCP port
Setting Factory Default Necessity
1 to 65535 4001 Optional
Each of NPort’s serial ports is mapped to a TCP port. To avoid conflicts with TCP ports, set port
numbers to 4001 for port1, 4002 for port 2, etc. (like the default values).
Map <CR-LF>
Setting Factory Default Necessity
CR, LF, or CR-LF CR-LF Optional
If data received through NPort 5400’s Ethernet port is sent using the “enter” command, the data will be
transmitted out the serial port with an added
(1) “carriage return + line feed” if you select the <CR-LF> option
(i.e., the cursor will jump to the next line, and return to the first character of the line)
(2) “carriage return” if you select the <CR> option
(i.e., the cursor will return to the first character of the line)
(3) “line feed” if you select the <LF> option.
(i.e., the cursor will jump to the next line, but not move horizontally)