Martin Fireplaces DMX Controller 2518 - Manual (Page 11)

11
4. Set effects with the faders. If there is no light, you may need to send
a lamp-on command - see the fixture’s DMX protocol.
5. Press the channel button again to turn fader control off.
6. Repeat for other fixtures. To activate fader control of high channels,
press the channel master to toggle to the high channels before
pressing the channel button.
P ROGRAMMING SCENES
Scenes contain one DMX value for every channel and determine how each light looks
at a particular moment. They are stored in 30 groups called banks. There are 6 scenes
per bank in single-controller mode and 12 scenes per bank in tandem mode. There is
also a flash scene that is not stored in a bank and thus can be executed at any time.
Scenes are programmed and executed one at a time. In single-controller mode, the
active scene is displayed as a 1-digit number and the active bank is displayed as a 2-
digit number.
T O CREATE AND SAVE A SCENE
1. Set your lights using the basic control procedure described above.
2. Press [Store]. The display flashes.
3. Press the up and down arrow buttons to select a bank.
4. Press a scene button from 1 to 6. The display stops flashing.
10
9
8
7
6
5
4
3
2
1
10
9
8
7
6
5
4
3
2
1
DMX Channels
1-6
(37-42)
7-12
(43-48)
13-18
(49-54)
19-24
(55-60)
25-30
(61-66)
31-36
(67-72)
1-36
(37-72)
1 2 3 4 5 6
Scenes
Blackout
(Standby)
Store
Auto
Music
Midi
Scene Bank
The channel master
toggles controls and
status between low
and high channels. Slide the faders to
adjust DMX values. Low channels active
when lit; high channels
active when flashing. Press a channel
button to toggle
fader control on/off.