Motorola Netopia 3342N - Manual (Page 174)

Administrator’s Handbook
174
1.
To add a filter, click the Add button under Input Rules.
The Input Rule Entr y page appears.
2.
If you want the filter to forward packets that match its criteria to the destination IP
address, check the
Forward checkbox.
If For ward is unchecked, packets matching the filter’s criteria will be discarded.
3.
Enter the Source IP address this filter will match on.
You can enter a subnet or a host address.
4. Enter the Source Mask for the source IP address.
This allows you to fur ther modify the way the filter will match on the source address. Enter 0.0.0.0 to
force the filter to match on all source IP addresses, or enter 255.255.255.255 to match the source IP
address exclusively.
5.
Enter the Destination IP Address this filter will match on.
You can enter a subnet or a host address.
6. Enter the Destination Mask for the destination IP address.
This allows you to fur ther modify the way the filter will match on the destination address. Enter 0.0.0.0
to force the filter to match on all destination IP addresses.
7.
If desired, you can enter a TOS and TOS Mask value.
See “Policy-based Routing using Filtersets” on page 177 for more information.
8.
Select Protocol from the pull-down menu: ICMP, TCP, UDP, Any, or the number of
another IP transport protocol (see the table on page 167 ).
If Protocol Type is set to TCP or UDP, the settings for por t comparison will appear. These settings only
take effect if the Protocol Type is TCP or UDP.
9. From the Source Port Compare pull-down menu, choose a comparison method for the
filter to use on a packet’s source port number.
Then select Source Port and enter the actual source por t number to match on (see the table on
page 166 ).
10.
From the Destination Port Compare pull-down menu, choose a comparison method for
the filter to use on a packet’s destination port number.
Then select Destination Port and enter the actual destination por t number to match on (see the table
on page 166 ).