Shell commands, Common commands – Motorola Netopia 3342N User Manual
Page 228
Administrator’s Handbook
228
SHELL Commands
Common Commands
arp
nnn.nnn.nnn.nnn
Sends an Address Resolution Protocol (ARP) request to match the nnn.nnn.nnn.nnn IP address to an
Ethernet hardware address.
clear [yes]
Clears the configuration settings in a Motorola Netopia® Gateway. If you do not use the optional
yes
qual-
ifier, you are prompted to confirm the
clear
command.
clear_certificate
Removes an SSL cer tificate that has been installed.
clear_log
Erases the log information stored in flash if persistent logging is enabled.
configure
Puts the command line inter face into Configure mode, which lets you configure your Motorola Netopia®
Gateway with Config commands. Config commands are described star ting on
.
diagnose
Runs a diagnostic utility to conduct a series of internal checks and loopback tests to verify network connec-
tivity over each inter face on your Motorola Netopia® Gateway. The console displays the results of each test
as the diagnostic utility runs. If one test is dependent on another, the diagnostic utility indents its entr y in
the console window. For example, the diagnostic utility indents the Check IP connect to Ethernet (LAN)
entr y, since that test will not run if the Check Ethernet LAN Connect test fails.
Each test generates one of the following result codes:
download [
server_address
] [
filename
] [confirm]
This command installs a file of configuration parameters into the Motorola Netopia® Gateway from a TFTP
(Trivial File Transfer Protocol) ser ver. The TFTP ser ver must be accessible on your Ethernet network.
CODE
Description
PASS
The test was successful.
FAIL
The test was unsuccessful.
SKIPPED
The test was skipped because a test on which it depended failed, or
because the test did not apply to your particular setup or model.
PENDING
The test timed out without producing a result. Try running the test again.