Assembly, Connect battery (see figs. 3 and 4) – McCulloch MC16H38ST User Manual

Page 7

Advertising
background image

7

ASSEMBLY

NOTE: You may now roll or drive your tractor off the skid.
Follow the ap pro pri ate instruction below to remove the
tractor from the skid

.

TO ROLL TRACTOR OFF SKID (See Op-
er a tion section for location and function of
con trols)

Press lift lever plunger and raise attachment lift lever
to its highest po si tion.

Release parking brake by de

press ing clutch/brake

ped al.

Place freewheel control in "trans mis sion dis en gaged
position" (See “TO TRANS PORT” in the Op er a tion
section of this manual).

Roll tractor forward off skid.

Remove banding holding the deflector shield up against
tractor.

TO DRIVE TRAC

TOR OFF SKID (See Op-

er a tion section for location and function of
con trols)

WARNING: Before start ing, read, un der stand and fol low

all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.

Be sure all the above assembly steps have been com-
pleted.

Check engine oil level and fill fuel tank with gasoline.

FIG. 2

ADJUSTMENT
KNOB

FLAT WASHER

02615

02617

SEAT PAN

SHOULDER
BOLTS

SEAT

02602

CONNECT BATTERY (See Figs. 3 and 4)

CAUTION: Do not short battery termi-
nals by allowing a wrench or any other
object to contact both terminals at the
same time. Before connecting battery,
remove metal bracelets, wristwatch
bands, rings, etc.

Positive terminal must be connected
first to prevent sparking from accidental
ground ing.

Lift seat pan to raised position.

Remove terminal protective caps and discard.

If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in the Maintenance section of this
manual for charg ing in struc tions).

First connect RED battery cable to positive (+) terminal
with hex bolt and keps nut as shown. Tighten securely.
Slide terminal cover over terminal.

Connect BLACK grounding cable to negative (-) ter-
minal with remaining hex bolt and keps nut. Tighten
securely.

02604

FIG. 3

FIG. 4

HEX BOLT

NEGATIVE (BLACK)
CABLE

POSITIVE (RED)
CABLE

KEPS
NUT

SEAT PAN

TERMINAL
COVER

DISCARD TER MI NAL
PROTECTIVE CAPS

LABEL

Advertising