Miele KM 451 - Manual (Page 33)

All electrical work should be by a
qualified electrician in accordance
with local and national codes.
To reduce the risk of electric shock,
disconnect the power supply by trip-
ping the circuit breaker or removing
the fuse to the unit before perform-
ing the installation or service.
^
Note to the installer:
Please leave these instructions with
the consumer.
Power supply:
Please check the data plate for:
– 240 VAC, 60 Hz, 50 A,
– 208 VAC, 60 Hz, 50 A.
Make sure your electrical supply
matches the data plate.
Important
The appliance is provided with 3 leads;
L1 (black), L2 (red) and GND (green).
They must be connected to a dedi-
cated line through the use of an ap-
proved junction box.
For further information, see the wiring
diagram provided with the appliance.
WARNING:
THIS APPLIANCE MUST BE
GROUNDED!
Electrical connection
33