Millennium Enterprises Integrated Modeling Amplifier - Manual (Page 21)

Section-2 Setting Up
Making Connections
Your Millennium can be connected in several different ways to meet the requirements of specific applications. The following diagrams offer
some different ways your Millennium can be connected.
NOTE: In the following diagrams, we have shown use of the external FX loop.
Millennium into Two 2X12 or 4X12 Extension Speaker Cabinets with Selectable Voicings
The Millennium Two-Fifty offers selectable voicing modes for using either 2X12 or 4X12 extension cabinets located in the Utility menu. To
select which voicing is to be used. From Program mode, press the <Utility> button and turn the <Data/Wheel> until you reach page 1. Now
use the <3> knob to select either the 2X12 or 4X12 voice. Once the selection has been made, press the <Program> button to exit. You can
now make connections from the left and right extension cabinet outputs (located on the rear of the Millennium). Use an un-shielded speaker
cable and run into the input jacks of either 2X12 or 4X12 extension cabinets. Always make sure that the extension speaker cabinet being used
has minimum input load resistance of 4 ohms.
Input
Loop Send
Left Speaker Output Right Speaker Output
Input Output
Loop Return
Johnson Millennium
User Guide
Section - 2 Setting Up
13