Maytag W10252706B User Manual

Page 10

Advertising
background image

10

Direct Wire Installation: Copper or Aluminum Wire

This range may be connected directly to the fuse disconnect or
circuit breaker box. Depending on your electrical supply, make
the required 3-wire or 4-wire connection.

1. Strip outer covering back 3" (7.6 cm) to expose wires. Strip

the insulation back

³⁄₈" (1.0 cm) from the end of each wire.

2. Allow enough slack in the wire to easily attach the wiring

terminal block.

3. Complete electrical connection according to your type of

electrical supply (4-wire or 3-wire connection).

4-wire Connection: Direct Wire

Use this method for:

New branch-circuit installations (1996 NEC)

Mobile homes

Recreational vehicles

In an area where local codes prohibit grounding through the
neutral

1. Part of metal ground strap must be cut out and removed.

2. Use a Phillips screwdriver to remove the ground-link screw

from the back of the range. Save the ground-link screw and
the end of the ground-link under the screw.

3. Pull the wires through the strain relief on bottom of range.

Allow enough slack to easily attach wiring to the terminal
block.

4. Attach terminal lugs to line 1 (black), neutral (white), and line 2

(red) wires. Loosen (do not remove) the setscrew on the front
of the terminal lug and insert exposed wire end through
bottom of terminal lugs. Securely tighten setscrew to torque
as shown in the following Bare Wire Torque Specifications
chart.

Bare Wire Torque Specifications

Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-m)

5. Use a hex or Phillips screwdriver to connect the bare (green)

ground wire to the range with the ground-link screw and
ground-link section. The ground wire must be attached first
and must not contact any other terminal.

A. Metal ground strap
B. Discard

C. Ground-link screw

3"

(7.6 cm)

³⁄₈

"

(1.0 cm)

A

B
C

A. Terminal block
B. Ground-link screw

C. Cord/conduit plate
D. Bare (green) ground wire

E. Line 2 (red) wire

F. Neutral (white) wire

G. Line 1 (black) wire

A. Terminal lug
B. Setscrew

C. Line 2 (red) wire
D. Neutral (white) wire

E. Line 1 (black) wire

Wire Awg

Torque

8 gauge copper

25 lbs-in. (2.8 N-m)

6 gauge aluminum

35 lbs-in. (4.0 N-m)

A

B

C

D

E

G

F

A

B

C

D

E

Advertising