Maytag W10252706B - Manual (Page 8)

8
4. Add strain relief.
Style 1: Power supply cord strain relief
■ Remove the knockout for the power supply cord.
■ Assemble a UL listed strain relief in the opening.
■ Tighten strain relief screw against the power supply cord.
Style 2: Direct wire strain relief
■ Remove the knockout as needed for the flexible conduit
connection.
■ Assemble a UL listed conduit connector in the opening.
■ Tighten strain relief screw against the flexible conduit.
5. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
4-wire connection: Power Supply Cord
Use this method for:
■ New branch-circuit installations (1996 NEC)
■ Mobile homes
■ Recreational vehicles
■ In an area where local codes prohibit grounding through the
neutral
1. Part of metal ground strap must be cut out and removed.
2. Use a Phillips screwdriver to remove the ground-link screw
from the back of the range. Save the ground-link screw and
the end of the ground-link under the screw.
A. UL listed strain relief
A. Removable retaining nut
B. Concuit
A
A
B
If your home has: And you will be
connecting to: Go to Section:
4-wire receptacle
(NEMA type 14-50R) A UL listed,
250-volt
minimum,
40-amp, range
power supply
cord 4-wire connection:
Power supply cord
4-wire direct A circuit breaker
box or fused
disconnect 4-wire connection:
Direct wire
3-wire receptacle
(NEMA type 10-50R) A UL listed,
250-volt
minimum,
40-amp, range
power supply
cord 3-wire connection:
Power supply cord
3-wire direct A circuit breaker
box or fused
disconnect 3-wire connection:
Direct wire
A. Metal ground strap
B. Discard
C. Ground-link screw
(12.7 cm)
5"
³⁄₈ "
(1.0 cm)
3"
(7.6 cm)
³⁄₈ "
(1.0 cm)
A
B
C