Moxa Technologies EM-1240-LX - Manual (Page 49)

EM-1240-LX User’s Manual EM-1240-LX Device API
5-2
RTC (Real-time Clock)
The device node is located at /dev/rtc. The EM-1240-LX supports µClinux standard simple
RTC control. You must include <linux/rtc.h> to use these functions.
1. Function: RTC_RD_TIME
int ioctl(fd, RTC_RD_TIME, struct rtc_time *time);
Description: Reads time information from RTC.
2. Function: RTC_SET_TIME
int ioctl(fd, RTC_SET_TIME, struct rtc_time *time);
Description: Sets RTC time.
Buzzer
The device node is located at /dev/console. The EM-1240-LX supports µClinux standard
buzzer control. The EM-1240-LX’s buzzer runs at a fixed frequency of 100 Hz. You must include
<sys/kd.h>
to use these functions.
1. Function: KDMKTONE
ioctl(fd, KDMKTONE, unsigned int arg);
Description: Buzzer will beep, as stipulated by the function
arguments.
UART Interface
The normal tty device node is located at /dev/ttyM0…ttyM1, and modem tty device node is
located at /dev/com0 … com1. The EM-1240-LX Series supports µClinux standard termios
control. Moxa UART Device API supports the configuration of ttyM0 to ttyM1 as
RS-232/422/485. To use these functions, after the Tool Chain package is installed, include
<moxadevice.h> in your application.
#define RS232_MODE 0
#define RS485_2WIRE_MODE 1
#define RS422_MODE 2
#define RS485_4WIRE_MODE 3
1. Function: MOXA_SET_OP_MODE
int mode;
mode=which mode you want to set;
int ioctl(fd, MOXA_SET_OP_MODE, &mode)
Description: Sets the interface mode.
2. Function: MOXA_GET_OP_MODE
int mode;
int ioctl(fd, MOXA_GET_OP_MODE, &mode)
Description: Gets the interface mode.