Maytag 661S/W - Manual (Page 31)

31
Fitting fixed kick-plate
Fitting strip seal
(on floor plinth covering plate)
Proceed as follows:
1. Remove the plastic plinth by gripping with
both hands under the plastic plinth(A), and
break outwards and upwards.
2. Undo the two screws on the covering
plate(B).
3. Glue the accompanying rubber strip(C) to
the underside of the covering plate (against
the floor).
4. Screw the covering plate back into place.
Adjust the covering plate so that the rubber
strip is just in contact with the floor.
5. Replace the plastic plinth
To prevent kinks, pull the drain hose and the
connecting pipe.
Installing the plinth
(Only with kick-plate as accessory)
The dishwasher has two kick-plates (some
models).
The taller one should be used if the machine is to
be 850 - 870 mm high and the depth of the plinth
can be varied between 45 - 105 mm. The lower
one is to be used if the machine will be 820 - 845
mm with a plinth depth of between 50 - 105 mm.
Attach the enclosed felt insulation to the kick-
plate (some models).
Set the correct plinth depth as follows:
1. Bring the grey hooks towards each other and
pull out the brackets as far as required. Press in
the catches so that they lock the brackets in
place.
2. Suspend the kick-plate from the brackets by
pushing into the slots.
Screw the dishwasher into place
The enclosed plastic plugs are used for covering
the screw holes if the dishwasher is to be
screwed at the sides. After fixing check that the
front feet are in contact with the floor.
A
B
x x x
C
Not all models