GIGABYTE 8S661FXMP-RZ - Manual (Page 27)

- 27 - BIOS Setup
English
Integrated Peripherals
IDE1 Conductor Cable
Auto BIOS autodetects IDE1 conductor cable .(Default Value)
ATA66/100/133 Set IDE1 Conductor Cable to ATA66/100/133 (please make sure your IDE
device and cable is compatible with ATA66/100/133).
ATA33 Set IDE1 Conductor Cable to ATA33 (please make sure your IDE device and
cable is compatible with ATA33).
IDE2 Conductor Cable
Auto BIOS autodetects IDE2 conductor cable. (Default Value)
ATA66/100/133 Set IDE2 Conductor Cable to ATA66/100/133 (please make sure your IDE
device and cable is compatible with ATA66/100/133).
ATA33 Set IDE2 Conductor Cable to ATA33 (please make sure your IDE device and
cable is compatible with ATA33).
On-Chip Primary PCI IDE
Enabled Enable onboard 1st channel IDE port. (Default value)
Disabled Disable onboard 1st channel IDE port.
On-Chip Secondary PCI IDE
Enabled Enable onboard 2nd channel IDE port. (Default value)
Disabled Disable onboard 2nd channel IDE port.
AC97 Audio
Enabled Enable onboard AC'97 audio function. (Default value)
Disabled Disable this function.
Item Help
Menu Level
X
[Auto]
Auto-detect IDE cable type
[ATA66/100/133]
Set Conductor cable to
ATA66/100/133
(80 pins)
[ATA33]
Set Conductor cable to
ATA33(40 pins)
IDE1 Conductor Cable [Auto]
IDE2 Conductor Cable [Auto]
On-Chip Primary PCI IDE [Enabled]
On-Chip Secondary PCI IDE [Enabled]
AC97 Audio [Enabled]
Onboard LAN device [Enabled]
USB Controller [Enabled]
USB Legacy Support [Disabled]
SiS Serial ATA Controller [Enabled]
SiS Serial ATA Mode [RAID]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 [2F8/IRQ3]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [ECP]
ECP Mode Use DMA [3]
KLJI: Move
Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Integrated Peripherals