Intermec 6110 - Manual (Page 69)

APPENDIX B PEN*KEY R Utilities Program
6110 Hand-Held Computer User’s Guide B-15
These error codes apply when COMM SETTINGS is set to
NRINET:
“0” No error
“6” User aborted communications by pressing
[ESC] key.
“800” PC TCP/IP kernel is missing.
“801” Invalid client IP address. Make sure the entry
for CLIENT IP ADDRESS is correct, or make
sure the DHCP server is running.
“802” Invalid Service or Service Type, or invalid port
number.
“803” Invalid host name or IP Address. Make sure
the entry for SERVER NAME is correct, and
that the server is running.
“804” Could not create socket. Check all cables and
network connections.
“806” Block sent was incomplete or block received
was incomplete.
“807” Client and server negotiation failed.
“808” Server specified an unsupported block size.
“809” Invalid buffer pointer.
“810” All server connections are already in use. Try
again later.
“811” Timeout while sending data. Connection to
remote machine dropped. Make sure the host
is still running, and check all cables and
network connections.
“812” Timeout while receiving data. Connection to
remote machine dropped. Make sure the host
is still running, and check all cables and
network connections.
“813” An attempt to send data to the server failed
due to a closed connection. Ensure the server
is still running, check all cables and network
connections.
“814” An attempt to receive data from the server
failed due to a closed connection. Ensure the