Invacare At'm - Manual (Page 42)

SECTION 10—WHEELS AND CASTERS
At’m 42 Part No. 1125035
REMOVING/INSTALLING THE DRIVE WHEELS
ƽ WARNING
Maintain tire pressure at 30 p.s.i.
NOTE: For this procedure, refer to FIGURE 10.3.
REMOVING
1. Disengage the motors. Refer to Engaging/Disengaging the Motors on page 39.
2. Push and hold the quick-release button on the drive wheel and pull the drive wheel
out of the wheelchair frame.
3. Repeat STEPS 1-2 for the other drive wheel.
INSTALLING
1. Align drive wheel axle with the wheelchair frame.
2. Push and hold the quick-release button on the drive wheel and push the drive wheel
into the wheelchair frame.
3. Engage the motor. Refer to Engaging/Disengaging the Motors on page 39.
4. Repeat STEPS 1-3 for the other drive wheel.
ƽ WARNING
Pull the drive wheel to ensure that the drive wheel is locked in place before operat-
ing the wheelchair - otherwise serious injury or damage may occur.
FIGURE 10.3 - REMOVING/INSTALLING THE DRIVE WHEELS
Motor Engagement Handle
in the Disengaged Position
Drive Wheel
Drive Wheel
Drive Wheel Axle
Wheelchair
Frame
TOP VIEW
SIDE VIEW
Quick-Release
Button