Troubleshooting, No sound, No image – Initial Technology DTV-172 User Manual
Page 49: Bad sound quality, Disc cannot be played, The unit doesn't operate normally, Remote control does not work, Page46
No sound
●
Check if the unit is connected securely.
●
Make sure the TV or amplifier is working properly.
●
Make sure the amplifier is set to receive DVD signal
output.
No image
●
Check if the unit is connected securely.
●
Make sure the TV is working properly.
●
Make sure the color system is set correctly.
Bad sound quality
●
Make sure the audio output mode is set correctly.
●
Make sure the audio connection between the unit and
amplifier is in place.
This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other
intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology
must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise
authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
Disc cannot be played
●
There is no disc in the unit.
●
Put the disc on the disc tray properly with the label
side up.
●
Clean the disc.
●
Moisture has condensed in the unit. Remove the
disc and leave the unit on for about an hour.
The unit doesn't operate normally
●
Disconnect the power plug and insert it into the wall
outlet again.
Remote control does not work
●
Remove barriers between the remote control and the
unit.
●
Point the remote control at the remote control sensor
of the unit.
●
Replace the batteries with new ones.
If you experience the following problems while using the unit, this troubleshooting guide can help you.
page46
TROUBLESHOOTING