Insignia NS-BT400 - Manual (Page 10)

8
Insignia NS-BT400
www.insignia-products.com
To pair your speaker with any Bluetooth A2DP device:
1 Turn on your speaker, then press and hold the PAIRING button for
three seconds, until the Pairing LED flashes blue three times.
2 Release the button. The Pairing LED alternately flashes blue and
red for 90 seconds, indicating that the speaker and the Bluetooth
device are in pairing mode.
3 Turn on the Bluetooth settings of your Bluetooth device, then
perform a search for Bluetooth devices in range. When the blue
LED flashes continuously, it indicates that the pairing process has
been completed successfully.
Your Bluetooth device should now display a new device named
“NS-BTS21” on the Bluetooth Device List.
4 Select “NS-BTS21” from the Bluetooth Device List. You are
prompted to enter a PIN.
5 Enter the default PIN of “0000.” Your Bluetooth device and the
speaker system are now connected through Bluetooth wireless
technology.
6 Select music on your Bluetooth device to play wirelessly through
your NS-BT400 speaker system.
To pair your speaker with a Bluetooth-enabled computer:
1 Start the Bluetooth application on your computer, then perform a
search for Bluetooth devices in range.
2 Turn on your speaker, then press and hold the PAIRING button for
three seconds, until the Pairing LED flashes blue three times.
3 Release the button. The Pairing LED alternately flashes blue and
red for 90 seconds, indicating that the speaker and your computer
are in pairing mode.
Your computer should now display a new device named
“NS-BTS21” on the Bluetooth Device List.
4 Select “NS-BTS21” from the Bluetooth Device List. You are
prompted to enter a PIN.
Note
If the pairing process cannot be completed within 90
seconds, the blue and red LED stops flashing and the
Bluetooth function is terminated automatically. If this
happens, you must initiate the pairing process again.
Note
If the pairing process cannot be completed within 90
seconds, the blue and red LED stops flashing and the
Bluetooth function is terminated automatically. If this
happens, you must initiate the pairing process again.