Insignia NS-A1113 - Manual (Page 24)

22
NS-A1113 DVD Executive Shelf System
www.insignia-products.com
Troubleshooting
For your convenience, we have listed some methods to solve
common problems you may encounter when using the system. If the
problem occurs repeatedly, contact your nearest maintenance center.
Note In most cases, whether the DVD player can work correctly depends
on the disc you are trying to play. Some features listed in the
instruction manual may not work properly due to disc problems.
Problem Cause and solution
Cannot operate the
system with the remote
control • Check the batteries in the remote control to see if
they need to be replaced.
• Use the remote control within 6 meters from the
system, and direct the remote control to the front
panel of the system.
Cannot play discs • Make sure that the disc is placed on the tray with
the label facing up.
• Play discs compatible with the DVD player.
• Switch off the player for a while and switch on
again.
• Parental control rating is set. Remove or change
the rating.
No disc menu is displayed Check if a menu is recorded.
Play mode is different
from what has been
chosen in the Setup menu If the disc has no corresponding function codes, some
features selected in the Setup menu may not work
properly.
Picture distortion or no
color displayed The TV system or video output of the system is not the
same as the TV set. Reset the TV system.
No picture is produced or
picture is produced
asynchronously The setup of the video output does not match the way
the system is connected with the TV set. Set up and
configure correctly.
The picture distorts or is
out of sync • When playing discs that are severely scratched or
have interior defects, or when the system is
affected by strong outer electromagnetic fields,
this problem occurs and normal operation of this
system is affected.
• Turn off the power for a while and turn it on again.
• Use a non-defective disc, and the system
resumes working normally.
• Unusually defective discs may shorten the
service life of this system.
No sound Cancel mute mode or turn up the volume.