Icom IC-F210 - Manual (Page 10)

7
2
OPERATION
■Turning power ON
q Push [ ] to turn the power ON.
w If the transceiver is programmed for a start up passcode,
input the digit codes as directed by your dealer.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are same.
e When the “PASSWORD” indication does not clear after
inputting 4 digits, the input code number is incorrect. In this
case, turn the power off and start over.
■Channel selection
Several types of channel selection are available. The meth-
ods may differ according to your system setup.
NON-BANK TYPE:
Push [
]/[ ] to select the desired operating channel in
sequence; or, push one of the [CH 1] to [CH 4] keys to select
a channel directly.
BANK-TYPE:
Push [BANK] to select the desired bank number or name.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the
microphone off hook.
KEY
NUMBER
0 1 2 3 4
5 6 7 8 9
IC-F110_F210_GEN.qxd 02.12.11 4:25 PM Page 7 (1,1)