Icom IC-F210 - Manual (Page 15)

12
3
OPTIONAL SmarTrunk II™ OPERATION
D Terminating a call
After completing a call, push [#] to disconnect (hang up).
IMPORTANT!: If one person in the conversation termi-
nates a call, all participants will be cut off.
D Last number re-dial
Push [M] 2 times to automatically re-dial the last called num-
ber.
• A high-pitched beep indicates that the number is accepted.
D Memory speed-dialling
To automatically dial a commonly used number from memory:
• Push [M] followed by the memory location (0–9).
D Turbo SpeeDial
To automatically dial a commonly used number with one
push:
• Push one of the turbo SpeeDial keys ([A], [B], [C] or [D]).
D Programming memory speed dial
q Push and hold [M] until you hear a high-pitched beep.
w Enter the memory location (0–9, A, B, C, D), the telephone
or subscriber number, then [1], [M] (or [3], [M] if for another
system subscriber).
• A high-pitched beep indicates successful programming.
• Memories [A]–[D] are used for the Turbo SpeeDial.
D System busy indication
If all channels are busy, three low beeps sound after you initi-
ate a call. Try the call again later.
D PTT dispatch operation
q Push [PTT] once (without dialling) to initiate a dispatch call.
w Begin talking after you hear three beeps (one short, high-
pitched, two very-short, low-pitched).
e Receiving a dispatch call is indicated by the same three-
beep sequence.
• It is not necessary to push [M] to answer a dispatch call.
D Emergency call
Push [0], [M] to initiate an emergency call.
• Contact your dealer for details.
D Clear channel alerting
If all channels are busy, the transceiver automatically begins
searching for an open channel and beeps every ten seconds.
When two short beeps (low-pitched, then high-pitched) are
heard, a channel is available. Push [M] two times immediate-
ly to re-dial the last number.
NOTE: For additional operating instructions, contact your
dealer.
IC-F110_F210_GEN.qxd 02.12.11 4:25 PM Page 12 (1,1)