Getting started – Iluv IMM173 User Manual

Page 3

Advertising
background image

GETTING STARTED

• This system is designed to operate on AC100V~240V 60/50Hz house current only.

• Connecting this system to any other power source may cause damage to the system and such

damage is not covered by your warranty.

• Main plug is used as the disconnect device, the disconnect device shall remain readily operable.

Power Source

Note:
The system has an AC plug and will only fit into matching AC
outlets. This is a safety feature to reduce the possibility of electric
shock. If the plug will not fit in your AC outlets, you should have
the outlet changed by a qualified, licensed electrician. Do not use
an adapter to make the plug fit into your outlet. This defeats the
safety feature and could expose you to electric shock.

This model is equipped with non-skid rubber ‘feet’ to prevent the product from moving when

you operate the controls. These ‘feet’ are made from non-migrating rubber material specially

formulated to avoid leaving any marks or stains on your furniture. However certain types of oil

based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber ‘feet’ to

soften, and leave marks or a rubber residue on the furniture. To prevent any damage to your

furniture we strongly recommend that you purchase small self-adhesive felt pads, available at

hardware stores and home improvement centers everywhere, and apply these pads to the bottom

of the rubber ‘feet’ before you place the product on fine wooden furniture.

Protect your Furniture

AC Plug

AC Oulet

The remote control battery has been previously installed and ready for operation for the first time

use. When the remote control stops functioning, replace the battery with a new one. To do so,

locate the battery compartment and follow the steps below:

Installing the Remote Control Battery

GETTING STARTED

1. Slide out the battery holder from the remote

control case.
2. Insert a “CR2025” 3V lithium battery making

certain to follow the correct polarity. Observe

the corresponding symbols (+/–).
3. Secure battery and push the battery holder

back into the remote control until it is

fully inserted.

Battery

door latch

A

B

iLuv | 4

iMM173 | V12M12_IM_EN_05082009

3 | iLuv

Advertising