Odel, Ndpoints, Raditional – Inter-Tel 8526 User Manual
Page 26: Isplay
14
Inter-Tel
®
Model 8524/8525/8526 User Guide
FINDING Y
O
U
R
W
A
Y
M
ODEL
8524/8525/8526 E
NDPOINTS
VS
.
T
RADITIONAL
T
WO
-L
INE
D
ISPLAY
E
NDPOINTS
The Model 8524, 8525, and 8526 endpoints are designed to emulate an Inter-Tel two-
line display endpoint. Some users may want to use both the Model 8524/8525/8526
endpoint and a two-line display endpoint. The following are the differences between
the Model 8524/8525/8526 and two-line display endpoints:
• The extension name and the time and date that normally appear on the display
endpoint when it is in idle mode will not appear on the display of the Model
8524/8525/8526. When the Model 8524/8525/8526 is idle, it is actually in
standby mode. In other words, the endpoint is not receiving a signal from the sys-
tem. The extension that shows on the display is programmed directly into the
endpoint. This conserves battery power on the endpoint.
• The dash (-) that shows in the extension is there because of the way the endpoint
is programmed to deal with 7- and 10-digit numbers. As soon as 5 digits are
entered it puts in one dash. Once 8 digits are entered, it puts in a second dash.
• The Model 8524/8525/8526 endpoint does not support the Japanese language fea-
ture.
The following table lists the button assignments for the two-line display endpoints,
and the corresponding button assignments for the Model 8524/8525/8526. Note that
L1 =
, and F1 =
.
LINE
1
FNC
1
BUTTON
DISPLAY ENDPOINT
8524/
8525/8526
BUTTON
DISPLAY ENDPOINT
8524/
8525/8526
1
Call 1
L1
11
Programmable Button 6:
Undefined
F4
2
Call 2
L2
12
Programmable Button 7:
CNF
F5
3
Call 3
L3
13
Programmable Button 8:
HOLD
4
Call 4
L4
14
Programmable Button 9:
TRANSFER
F8
5
IC (Intercom)
L5
15
Programmable Button 10:
SYS SPD
F9
6
Programmable Button 1:
Do-Not-Disturb
L6
16
Programmable Button 11:
REDIAL
F7
7
Programmable Button 2:
Undefined
L7
26
FWD
F2
8
Programmable Button 3:
Undefined
L8
30
SPKR*
9
Programmable Button 4:
Undefined
L9
31
MSG
F6
10
Programmable Button 5:
Undefined
F3
32
MUTE
F1
*This applies to two-line display endpoints only.
HOLD
START