IMC Networks AccessEtherLinx/4 - Manual (Page 13)

10
ifstats Displays Ethernet statistics.
rmstats Displays RMON statistics.
cleandb Reboots the AccessEtherLinX/4 with a clean database. This removes all
of the information in the database with an option to change the IP
address of device.
download Opens the Download dialog from which you download firmware from
the server address entered in Server IP Addr in the Main Configuration
screen using TFTP protocol.
version Displays the AccessEtherLinX/4 serial number and build date.
vlan Displays and changes VLAN settings (see Configuring VLANs)
reboot Reboots the unit
security Allows ARP request configuration
accounts Allows addition/deletion of Username/Password accounts.
Administrators must maintain a password list.
unit Unit Global Settings
port Displays port status values and allows some configuration (See Port
Configuration section)
bw Bandwidth Limiting Controls
dlsecure* Downlink ports are isolated from one another (i.e. there is no
communication between downlink ports).
(Configuration is not cleared by the cleandb.)
dl_open * Downlink ports can communicate with each other.
bpdu Turns on/off the passing of BPDU packets (Bridge Protocol Data
Units)
sysdescr Allows the editing of sysName, sysDescr, and Port information
text.
*Perform a reboot after using the dlsecure and dl_open commands.
Downloading Files
Firmware for the AccessEtherLinX/4 can be downloaded from a central server via
TFTP protocol. Initiate this download via serial configuration or Telnet session. To
download a file, type download and press Enter to be taken to the “Download a file”
screen. This screen displays the IP Address of the TFTP server and the name of the
file to be downloaded. The TFTP server should be open. Make sure the IP Address
and the name of the file are correct in the Current Values section of the Main
Configuration screen. These are changed by entering I from the Main Configuration
screen. Press Enter to start downloading the file.