IMC Networks AccessEtherLinx/4 - Manual (Page 15)

12
NOTE
SNMP can only be associated with one VLAN group. Tags cannot be enabled on SNMP
traffic. Users can assign each port plus SNMP a priority in the VLAN Definition screen. The
high and low priority is determined by the Base VLAN of the unit. Use iView² to set the Base
VLAN priority; this value is not configurable via a serial/Telnet session.
Configuring Multiple VLAN IDs per Port
Make sure to configure the unit for dl_open mode and reboot the unit. Upon
enabling VLAN functionality, the following screen will appear:
When using dl_open mode, define up to 15 VLAN IDs. Configure the Uplink port for
Tags in order for it to accept VLAN tagged traffic. In this mode, users can configure
Downlink ports as Members of various VLAN IDs.
When defining a VLAN ID for SNMP, the Uplink port should also be a member of
this VLAN ID. The Downlink port can be configured as a member of the SNMP
VLAN.
Configuring a VLAN ID for Each Port
Make sure to configure the unit for dlsecure mode and reboot the unit. Upon
enabling VLAN functionality, the following screen will appear.