Invacare 9000 SL - Manual (Page 28)

9000 Series 28 Part No. 1056953
FIGURE 3 - FOOTPLATE HEIGHT ADJUSTMENT - BOLT-IN-PLACE
HEIGHT ADJUSTMENT
BOLT-IN-PLACE HEIGHT ADJUSTMENT (FIGURE 3)
NOTE: This procedure applies to the swingaway footrests and swingaway elevating legrest.
1. Remove the swingaway front rigging. Refer to INSTALLING/REMOVING THE
FRONT RIGGINGS in this section of the manual.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2. Pull the cam lock lever UP to UNLOCKED position.
3. Using a screw driver to hold the riv nut in position, remove the button head screw
from the riv nut.
4. Remove the riv nut and button head screw securing the footplate assembly to the
front rigging support.
5. Adjust the footplate assembly height by aligning the desired adjustment holes in the
upper front rigging support and lower footplate assembly.
6. From the outside of the swingaway front rigging, insert the riv nut through both the
front rigging support and the footplate assembly.
7. From the inside of the swingaway front rigging, insert the button head screw
through the appropriate adjustment hole and thread into the riv nut.
8. Using a screwdriver to hold the riv nut in position, securely tighten the button head
screw. Torque to 32 in-lbs.
9. Rotate cam lock lever DOWN to LOCKED position.
10. Repeat STEPS 1-9 to adjust the remaining footrest.
OUTSIDE OF
SWINGAWAY
FRONT
RIGGING
Riv Nut
INSIDE OF
SWINGAWAY
FRONT
RIGGING
Button Head Screw
Footplate
Assembly
Front Rigging
Support
Cam Lock Lever
Adjustment Hole
NOTE: Swingaway footrests shown.
Riv Nut
Button Head
Screw
Footplate Assembly
Front Rigging
Support
Adjustment
Hole
SECTION 3 FRONT RIGGINGS
FRONT
RIGGINGS