InSinkErator GN1100 - Manual (Page 10)

The Installation, page 3 of 5
7. Make Plumbing Connections
10
With all of the components secured in place, the tubing connections can be made.
When routing the tubing between components, several guidelines should be observed:
• Tubing runs should generally follow the contour of the cabinet rather than interfere
with the cabinet storage area.
• Arrange the tubing so that there are no sharp bends. Leave
some extra length in the tubing for ease of servicing, then cut
tubing to the desired length.
• Insert tubes completely into all quick-connect fittings to
the stop (minimum depth of 1/2").
• The polyethylene tubes can be cut, but caution should be
exercised to ensure that a clean (burr-free) cut is made
perpendicular to the tube.
Completely insert 3/8"
polyethylene tubing into
inlet side of filter head. Completely insert 3/8"
polyethylene tubing into
outlet side of filter head.
Completely insert
dispenser faucet copper
tube (marked with white
tape) into the quick-
connect union fitting.
Model GN1100
Completely insert 3/8"
polyethylene tubing from
outlet side of filter head
into 3/8" to 1/4 quick-
connectunion fitting.