IDEAL INDUSTRIES IZGS 68 ICTX - Manual (Page 15)

15
The appliance is designed to be
connected to 230 V monophase
electricity supply.
The connection must be carried out
in compliance with the laws and
regulations in force.
Before the appliance is connected:
1) check that the main fuse and the
domestic installation can support the
load (see the rating label);
2) check that the power supply is
properly earthed in compliance with the
current rules;
3) check the socket or the double
pole switch used for the electrical
connection can be easily reached with
the appliance built in the forniture unit.
The appliance is supplied with a
connection cable and the relevant plug.
The plug has to be fitted in a proper
socket.
If connecting the appliance directly to
the electric system, it is necessary that
you install a double pole switch between
the appliance and the electricity supply,
with a minimum gap of 3 mm. between
the switch contacts and of a type suitable
for the required load in compliance with
the current rules.
The connection cable has to be placed
in order that, in each part, it cannot reach
a temperature higher than 90°C.
The brown coloured phase cable
(fitted in the terminal block contact
marked with "L") must always be
connected to the network phase.
Electrical Connection