Invacare Wheelchair Atlas - Manual (Page 23)

SECTION 4—FRONT RIGGINGS
Part No. 1130169 23 Atlas™
Adjusting Footrest Height
NOTE: For this procedure, refer to
FIGURE 4.2.
1. Loosen, but DO NOT remove, the screw
and locknut that secures the lower
footrest assembly to the upper footrest
support.
2. Reposition the lower footrest assembly
to the desired height.
3. Securely tighten the screw and locknut
that secures the lower footrest
assembly to the upper footrest support.
4. If necessary, repeat STEP 1‐3 for the
opposite side of the wheelchair.
FIGURE 4.2 Adjusting Footrest Height
Raising/Lowering Elevating Legrest Assembly
NOTE: For this procedure, refer to FIGURE 4.3.
1. To raise the elevating legrest, the assistant or user should hold the support tube and
raise the elevating legrests until the desired height is obtained.
2. To lower the elevating legrest, perform the following:
A. Support the user leg with one hand.
B. Push legrest release lever down with other hand.
C. Gently lower user leg down and rest it against the legrest.
FIGURE 4.3 Raising/Lowering Elevating Legrest Assembly
Locknut
Lower Footrest
Assembly
Upper
Footrest
Support
Screw
Legrest Release Lever
Support Tube