Intel WalkAbout Computer - Manual (Page 11)

Chapter 2 – Hardware Operation
WalkAbout Computers HAMMERHEAD RT User’s Guide – V030105 21
batteries in less time, compared to the current WalkAbout external
battery charger. Typical Charge Time per battery is 1.7 hours.
When should I calibrate my batteries?
You should calibrate your batteries if the HH Control Panel on your unit
indicates a max error of greater than 2%. To check the max error of the
battery, go to START, PROGRAMS, HHUTILITIES, HH Control Panel.
Click the Information Button, then click the BATTERIES button. On the
upper right, select the battery radio button of the battery you wish to look
at. The “Max Error” is shown on this screen.
Note: Only calibrate batteries when they need it. Calibrating a battery
unnecessarily will increase the cycle count and thereby reduce the
battery life.
What are the Over Temperature and Over Voltage boxes in the HH
Control Panel?
To insure the safety of the Hammerhead Computer at all times, the HH
Control program monitors battery temperature and voltage. If a
malfunction ever causes either of these values become too high, the
computer will shut down to prevent any permanent damage to the
computer.
Removable hard drive
The hard drive compartment allows field upgrades or repairs without
opening the HAMMERHEAD RT. Some customers may have IT
Departments that will be trained to replace hard drives at the customer
location. You should not open the hard drive compartment without
the proper training from WalkAbout Computers. Please contact
WalkAbout technical support 888-872-1100 before removing the cover
plate of the hard drive compartment. Any tampering of the hard drive will
result in a void warranty.
Chapter 2 – Hardware Operation
WalkAbout Computers HAMMERHEAD RT User’s Guide – V030105 22
Connectivity
Most often connectivity with the HAMMERHEAD RT is via the docking
connector on the backside of the unit. Most customers also purchase a
port replicator, DESKDOCK, or HAMMERDOCK vehicle dock that
provides standard ports for communications, keyboard, and power
supply. Port replicators and docking stations may be customized to your
requirements and may not be configured exactly as described below.
Port replicators
There are several variations of port replicators (flat, angled, custom, etc.)
New connectivity options are constantly in development. The following
features are available on the standard port replicator.
Male docking The male docking connector is inserted into the
connector:
female docking connector on the back of the
computer to activate all ports in the port
replicator.
External
External power connector. Use only the
power: power supplies provided especially for the
HAMMERHEAD RT, which supply the required
DC power from a standard AC outlet.
COM3
or
VGA