IBM Partner Pavilion 9013RF - Manual (Page 7)

3
3 Hardware Installation
Slide Switch Setting
Step 1: Make sure your PC is switched off.
Step 2: Take the receiver and select channel CH1 or CH2 by using the slide
switch on the side of the receiver. (Remember your selection.)
CH1
CH2
Step 3: Connect the receiver to your PC by plugging in the receiver’s PS/2
mouse connector into the mouse port of your PC and the PS/2 keyboard
connector into the keyboard port.
Step 4: Take the keyboard and make sure the batteries on the back are
installed correctly. (Follow the polarity signs in the battery compartment.)
Channel Switch
(-)
Battery 1.5V 2pcs
(+) ID Button
Back View of Receiver Channel Switch of Receiver
Bottom View of Keyboard
Mouse Connector Keyboard Connector