IBM THINKVISION MONITOR L150 - Manual (Page 15)

13
D
EU
TS
C
H
EN
G
LI
SH
FR
A
N
Ç
A
IS
ES
PA
Ñ
O
L
IT
A
LI
A
N
O
JA
PA
N
ES
E
C
O
M
PL
&
W
A
R
R
Auto Setup
Auto Setup
The Setup Utility
included on the installation
CD is for displaying dot patterns.
They do not replace or modify the
display driver.
The Auto Setup instructions
require the monitor to be warmed
up for 15 minutes. This is not
required for normal operation.
By pressing the Auto key, you will
have direct access to Auto
Adjustment.
When you first use your monitor you must perform Auto Setup. This
procedure sets up your monitor to process the video signals from your
computer without image discoloration or smearing. After you perform Auto
Setup, the settings are stored and used each time you turn on the monitor.
To optimise the displayed image a set-up utility is provided on the CD.
Operation of the utility is dependent on the operating system on your
computer. For correct operation locate the operating system on your
computer from the table below and follow the appropriate instructions. You
can choose to run A
UTO
S
ETUP
for each operating system that you use. This
means that if you sometimes use your monitor while running any version of
Windows and sometimes also use it from within DOS (not a DOS window),
you must run A
UTO
S
ETUP
for both Windows and DOS. You can run versions of
A
UTO
S
ETUP
in any order.
Before you begin A UTO S ETUP
for your computer:
1. Make sure the computer’s video mode is set in the range of the
supported screen resolution shown in the Table on page 23.
The A UTO SETUP process
only applies to the current
screen mode. When a new mode
is selected, repeat this section to
reset the monitor.
You should perform A UTO S ETUP
for each screen mode you use.
Operating System Corresponding Auto Setup procedure
DOS Auto Setup for DOS on page 14
Windows 95, WIndows 98,
Windows 2000,
Microsoft Windows NT®,
Windows Me or Windows XP
Auto Setup for Windows 95, Windows 98,
Windows NT, Windows 2000, Windows Me or
Windows XP on page 15
Auto setup is not required when using digital input.