Inter-Tel 831.10507 - Manual (Page 21)

21
9. SYMPTOM: THE WATER LEVEL DROPS
a. Some water loss due to evaporation is normal.
If rapid water loss occurs, or if you notice wet-
ness on the floor around the hydrotherapy spa,
then the spa shell may have a leak. Contact
your local spa and pool service provider for
repairs.
b. A clamp or seal in the interior of the spa may
be loose. Remove the access cover (see
ATTACHING AND REMOVING THE ACCESS
COVER on page 16). Check inside the access
opening for excess water and watch the pump
unit while it is operating to see if water drips
from any of the plumbing. If you can identify the
location of the leak, tighten the clamp or
replace the damaged seal.
10. SYMPTOM: THE SPA CONTINUES TO RUN
AFTER IT HAS BEEN SHUT OFF
a. To turn the spa jets on high, press the Pump
button once. To turn the spa jets on low, press
the control twice. To turn the spa jets off, press
the control three times. The spa jets will remain
off for three hours, at which time they will begin
running the filter cycle. At any time after the spa
jets has been shut off, the pump will begin
cycling the water if the temperature falls below
the minimum setting. Note: If the water is
already below the minimum setting, the
pump will not shut off.
11. SYMPTOM: NO AIR FLOWS THROUGH THE
MULTI-DIRECTIONAL HYDRO-JETS WHEN
THE AIR CONTROL IS TURNED COUNTER-
CLOCKWISE
a. The six multi-directional hydro-jets can be
closed and opened by pushing and pulling the
nozzles. If no air flows through the jets when
the air control is turned counterclockwise, simply
pull the nozzles slightly.