IBM PC 300GL - Manual (Page 16)

Chapter 2. System board features 9
The integrated video subsystem supports all video graphics array (VGA) modes and
is compliant with super video graphics array (SVGA) modes and Video Electronics
Standards Association (VESA) 1.2. Some enhanced features include:
• Integrated video subsystem on chip, including 2D, 3D, and video port
• 66 MHz AGP system bus interface with 2X and 4X
• Sideband signaling (some models only)
• Command list bus mastering support for fast 2D and 3D performance
• 64-bit, 125 MHz SDRAM or 166 MHz SGRAM interface
• Plug and Play support
• 4 MB dynamic display cache memory
• Advanced Power Management (APM) support
• Color space conversion
• Hardware scaling
The integrated graphics memory controller subsystem complys with the VESA
Display Data Channel (DDC) 1.1 standard and uses DDC1 and DDC2B to determine
optimal values during automatic minor detection.
The video subsystem has the following resource assignments.
For further information on resource assignments, see “Appendix B. System address
maps,” on page 47 and “Appendix C. IRQ and DMA channel assignments,” on page
53.
Table 2. Video subsystem resources
Resource Assignment
ROM Hex C0000-C7FFF (32KB)
RAM Hex A0000-BFFFF (standard VGA frame buffer)
I/O VGA, sequencer, CRT controller, graphics controller, attribute, RAMDAC,
extended sequencer, extended CRTC registers
IRQ PCI interrupt 1 (enabled by default in the Configuration/Setup Utility
program. Normally assigned to IRQ 0B when nothing else is installed in
the system. 3D systems use this interrupt.)
DMA None, N/A for AGP bus