Infinite Peripherals DPP-350 - Manual (Page 14)

. . . . . . . . . . . . . . . . . . . .
Infinite Peripherals, Inc.
www.ipcprint.com Page 14
DPP-350 User Manual v1.09
Dip Switch Settings
The DPP-350 is designed to use different methods of
communications. Care must be taken to ensure that the DIP
Switches are not changed from its default factory configuration
unless required.
♦ DIP SWITCH SETTINGS:
The printer has two absolutely different operation modes.
They are determined by the state of switch Sw2:
• OFF ESC/POS mode
• ON Hex Dump mode
These two modes have absolutely different list of commands that
are both described below. As the different operation modes use
one and the same memory, the switching from one mode to
another can cause lost of data and settings of the active mode as
follows:
• Switching to Hex Dump mode deletes loadable fonts and
logo of ESC/POS mode.
• Switching to ESC/POS mode deletes all forms, graphics
and fonts that were loaded in Hex Dump mode.
Switch OFF ON
Sw1
Wide paper/label roll
(78 мм)
Thinner paper/label roll
(58 мм)
Sw2 ESC/POS mode Hex Dump Mode
Sw3 Hardware protocol Xon/Xoff protocol
Sw4 Normal operation mode Protocol mode
Table 6