Integra DPS-8.3 - Manual (Page 68)

68
Register the Codes of Other Unit's Remote
Controllers
Register the codes of other unit's (TV
or VCR) remote controllers
Use this feature to register the remote codes of other
remote control units. Please look up your TV/VCR from
list of remote control codes starting on page 69.
While pressing and holding down
the desired Mode button (VCR or
TV) on the remote controller press
+10 and then release both buttons.
When you press and hold down the
desired Mode button, the Send/Learn
indicator lights up. When you press the
Display button, the indicator turns off.
When the Send/Learn indicator turns off,
release the buttons and the indicator lights
up again.
Use the number buttons on the
remote controller to input the
TV/VCR three digit remote control
code.
The Send/Learn indicator flashes twice
slowly to indicate that the command has
been successfully programmed.
If you perform an invalid operation, the
Send/Learn indicator flashes three times
quickly. Follow the same procedure again.
1
2
POWER
POWER
Program Channel +
Program Channel –
Volume +
Volume –
TV/VCR
Mute
1
2
3
4
5
6
7
8
9
+10, --/---
0
ENT, OK
RC-499DV button names TV
POWER
POWER
Program Channel +
Program Channel –
TV/VCR
Play
Stop
FF
FR
1
2
3
4
5
6
7
8
9
+10
0
ENT, OK
PAUSE
VCR
(ON)
(STANDBY)
CH +
CH –
VOL %
VOL fi
A/AUDIO SEL/TV/VCR
VIDEO OFF/M/MUTING
£
7
¡
1
1
2
3
4
5
6
7
8
9
+10
0
ENTER/SEARCH
(PAUSE)
Operate other units with the registered
codes
If you are unable to operate other units with the
RC-499DV remote, perform the registration procedures
again.
RC-499DV
Mode
On Standby
Input Selector
Audio SEL
Video Off
Display Dimmer
TV / VCR
Step/ Slow Pause Step/ Slow
Muting
Enter
A-B Picture Cond M Function M
Speed
Surround
Random Program Clear Repeat
-- / ---
VOL C H
Light
Search
1 2 3
4 5 6
7 8 9
+10 0
Au dio
Angl e
Top Menu Menu
Retu rn Setu p
M
DIM DIS
A
RPT RND PGM CLR
A-B PIC C.M F. M
DV D TV
VCR RCVR
Subttl
Las t M
TV.VCR /
VCR
Search
Send/Learn
TV
Erasing Registered codes
1
2
Remove the batteries from the
remote controller.
While pressing and holding down
the On and Standby buttons,
reinsert the batteries.
Press the Search button. 3
Note
The above procedure will completely remove all registered codes
from the remote controller.