Ironman Fitness 320t - Manual (Page 15)

Program and Operation
PROGRAM MODE
Plug treadmill into a surge protector outlet. Attach the Safety Key on to the treadmill console.
1. Stand on the treadmill and straddle belt. Attach safety key clip to your clothes.
2. Press POWER button. There will be an eight (8) second delay before data can be entered. The TIME window will
flash.
3. There are four (4) pre-set and eight (8) semi-custom pre-set programs on the Ironman TRIAD. The treadmill
includes FAT BURN, CARDIO, WARM-UP, and CROSS TRAINING programs. Press the PROGRAM UP or
DOWN button to select which program you wish to use. Press ENTER.
4. Press START/STOP button. Belt will begin to move after 4 seconds. Step on belt slowly after the belt starts moving.
CUSTOMIZING PROGRAMS in P1 and P2 Mode:
Each pre-set program (Fat Burn, Cardio, and Warm-up) can be customized in the P1 or P2 mode. After making the
program selection, the CAL / DIST window will read “OP”. The “OP” refers to “original program” and is preset.
The program name you select will illuminate on the console display. Press the PROGRAM DOWN button once
more and the CAL / DIST window will read P1. The “P1” mode is now accessed. You can now program the Time,
Speed, and Incline in P1 mode, which will be saved for future workouts.
1) The TIME window will blink. Use the SPEED + or – buttons to select your workout time. Press ENTER PROGRAM.
2) The SPEED window will then blink. Use the same + or – buttons to select the speed for your workout. Press ENTER
PROGRAM.
3) The INCLINE window will then blink. Use the INCLINE + or – buttons to set your workout incline. Press ENTER
PROGRAM.
To start, press the START/STOP button. To access P2 mode, press the PROGRAM UP or DOWN button for desired
program, then press the ENTER button (once for OP, twice for P1, three times for P2). Follow the above steps 1-3 to
customize P2 settings.
TO CHANGE A PREVIOUSLY PROGRAMMED P1, P2, or user program:
Once you have programmed the P1 or P2 modes, you will need to use the PAUSE button to change the program you
previously entered. For instance to change to a new setting in P1-FAT BURN, press the PROGRAM UP or DOWN
to select the FAT BURN program. Next, press the same button once more to access P1. Then press the PAUSE but-
ton to get the TIME window to flash. Follow the directions above to continue to change the program.
15
PROGRAM
UP / DOWN
START / STOP
INCLINE
POWER PAUSE
ENTER PROGRAM
SPEED / TIME