Ironman Fitness 320t - Manual (Page 5)

Assembly
The IRONMAN 320t TREADMILL will require assembly before operating. After opening the box, remove
any packing material from the treadmill.
Do not throw away any packing materials until the unit is working properly.
Place the base on a clean, level surface. Make sure the electrical cord will easily reach an electrical outlet.
Locate the hardware pack and identify the following parts required for assembly.
Tools:
1. Allen Wrench- 3/16”
2. Allen Wrench- 7/32”
3. Philip Screwdriver
Main Components:
1. Owner’s Manual
2. Console Assembly
3. Left and Right Uprights
4. Left and Right Fender
5. Left and Right Bottom Handle Cover
6. Handle End Caps
7. Deck Assembly
8. Long Bumpers
9. Chest Strap
Hardware:
1. Washer 9*22*2 mm (Large) (Qty 4)
2. Washer 9*16*1.6 mm (Small) (Qty. 8)
3. Spring Washer 8 mm (Qty. 12)
4. Allen Bolt 5/16”-18 x 70 (Long) (Qty. 4)
5. Allen Bolt 5/16”-18 x 15 (Short) (Qty. 6)
6. Shoulder Allen Bolt 5/16”-18 x 45 (Qty. 2)
7. Philip Screw ST4.2*16 (Qty. 8)
Wire Connections:
1. Console Harness
2. EKG Harness
5