IBM Dual AMD OpteronTM SFF Barebone ZMAXdp - Manual (Page 15)

SFF Workstation Installation Guide
User’s Manual 15
Chapter 2
Step-by-step instructions on how to install basic components.
This section outlines how to install and configure your ZMAXdp.
Refer to the following mainboard layout to help you to identify
various jumpers, connectors, slots, and ports. Then follow these
steps designed to guide you through a quick and correct
Installation of your system.
IWILL has designed the ZMAXdp for an IWILL motherboard only.
It is not advisable to install other motherboards.
Always turn the power off before you open the system or connect
your computer to peripheral equipment. Otherwise, damage may
occur to the integrated circuits in your computer.
Electrostatic discharge (ESD) may damage HDDs and other
components. Follow the procedures described here only at an ESD
workstation. Ground yourself by maintaining continuous contact with
an unpainted metal portion of the chassis while installation.
Assembling the System