Intel D865GBF - Manual (Page 35)

Installing and Replacing Desktop Board Components
35
Installing and Removing an AGP Card
CAUTION
When installing any AGP card in the desktop board, ensure that it is fully seated in the AGP
connector before you power on the system. If the card is not fully seated in the AGP connector, an
electrical short may result across the AGP connector pins. Depending on the over-current
protection of the power supply, certain board components and/or traces may be damaged.
The AGP connector supports 0.8 V (4x and 1x) and 1.5 V (8x) AGP cards. The desktop board has
an integrated AGP card retention mechanism (RM).
Installing an AGP Card
Follow these instructions to install an AGP card:
1. Observe the precautions in “Before You Begin” on page 25.
2. Place the card in the AGP connector.
3. Press down on the card until it is completely seated in the AGP connector and the card retention
notch snaps into place around the RM pin.
4. Secure the card’s metal bracket to the chassis back panel with a screw.
Removing the AGP Card
Follow these instructions to remove the AGP card from the RM (see Figure 10):
1. Observe the precautions in “Before You Begin” on page 25.
2. Remove the screw (B) that secures the card’s metal bracket (A) to the chassis back panel.
3. Push back on the RM lever (C), as shown in Figure 10, until the retention pin completely clears
the notch in the card.
4. Pull the card straight up (D).
OM15031
A
B
C
D
Figure 10. Removing the AGP Card