Integra DPS-6.7 - Manual (Page 23)

23
Connecting the DVD player —Continued
Connecting the Multichannel Analog
Output
Connect the DVD player’s FRONT/D.MIX 1 or 2,
SURR 1, CENTER, and SUBWOOFER jacks to the
multichannel analog audio input on your AV receiver.
You can use three stereo audio cables for this.
■ If Your AV Receiver has a 7.1-channel Analog
Audio Input
Connect the DVD player’s SURR 1 jacks to your AV
receiver’s surround input jacks, and connect the
SURR 2 jacks to your AV receiver’s surround back
input jacks. The SURR 1 and SURR 2 outputs output
the same signals.
When you make this connection, set the SURR MODE
switch to “1+2.”
If you use this connection, the output level will be
reduced by 3 dB (i.e., the volume level will be reduced
slightly).
• The remote controller supplied with Integra/Onkyo
AV receiver or amplifiers can be used to control the
DVD player.
• The function of the upper and lower connectors
are the same. Connect to either one.
• To use , in addition to an connection, you must
also make an analog audio connection (RCA) between
the DVD player and your other
-capable compo-
nents.
SURR1
ANALOG
CENTER
1 2
FRONT/D. MIX
AUDIO OUTPUT
SUB
WOOFER
R L
FRONT
SUB
SURR
CENTER
AV receiver
Connecting -compatible
Components
REMOTE
CONTROL
REMOTE
CONTROL
L
R
IN
1 2
FRONT/D. MIX
AV receiver