Invacare Arrow - Manual (Page 217)

MKIV Controller, Programmer and Hardware
NOTE: Gearless/ Brushless motors were made available on-chair as an option for Storm Arrow and
Ranger X 4/1/99. On 7/1/99 Gearless/ Brushless motors became standard for Storm Arrow only.
A - Extension cable to be used for the purpose of testing chairs only.
B - RII retro controller after 4/30/00 and RII joystick #1092610 are direct replacements for joystick/controller #1080723.
C - Controller without instructions before 4/1/02 is #1079890 and after 3/31/02 is #1109528 as noted on the controller decal.
D - It is recommended that item 13 be ordered when a new MKIV quad pulse or RII controller is needed and an E.S.D. strap
kit for the (G/B) controller. Hardware changed 4/12/01.
E - Before 4/1/02. No Longer Available. Use part number 1109540 as a replacement.
F - After 3/31/02.
G - Not Shown.
H - Used on torque.
I - Includes items 4-11.
J - Includes items 4, 7, 8, and 9 along with instruction sheet.
K - May be ordered as an individual part or is included in the "Virtual Service Modem Kit."
L - May be ordered as an individual part or is included in the "Virtual Service Software Kit."
M - These items are included in the "Mark III Printer Option."
N - Not Shown. After 5/23/04 the Egg Reset Switch became available as a service part and can be used as a direct
replacement for the tape reset switch part # 1020818.
O - Thumbscrews are used on the GB Controller motor cable connectors to secure the connection to the motor.
NOTE:
216
To order call toll free 1-800-333-6900, or www.invacare.com
Form No. 94-113