Iiyama LM704UT - Manual (Page 11)

ENGLISH
OPERATING THE MONITOR 7
OPERATING THE MONITOR
To create the best picture, your iiyama Vision Master has been preset at the factory with the signal
timings listed on page 13 in PRESET MODES. If an incorrect picture appears during the operation,
adjust the image by following the procedure below to get the desired picture.
For example, to adjust the contrast, select (Contrast) on the
Main Menu by using the +/– Buttons.
B
The On Screen Display disappears several seconds after you stop pressing the buttons while
performing an adjustment. The Exit Button can be used to exit OSD window immediately.
n
n
NOTE
An adjustment scale will turn red when you press the Menu Button.
Use the +/– Buttons to adjust the contrast. See ADJUSTMENT MENU
CONTENTS on next page for further information. C
(
Adjustments for Size, Position, Pincushion, Trapezoid, Pin Balance, Parallelogram and Moire are
saved for each signal timing. Except for these adjustments, all other adjustments such as Contrast,
Brightness, Color and Rotation have only one setting which applies to all signal timings.
Main Menu appears on the screen when you press the Menu Button.
70
V: 85Hz H: 68.8KHz
Contrast
OPQ Enable
R
G B
OSD
Adjustment icon
Adjustment menu
presently selected
OPQ function: ON
The line shows the
p r o g r e s s o f t h e
adjustment being
made.
Whenever you press the Menu Button for more than 5 seconds, the OPQ function (=Optimize
Picture Quality) is switched ON and OFF alternately. Turn ON the OPQ function to get the optimum
picture quality when displaying DVD or other moving pictures. (See page 3 for ATTENTION FOR
USING THE OPQ FUNCTION.)
n
n Any changes are automatically saved in the memory when the On Screen Display disappears.
Turning off the power should be avoided while using the Menu.