Intel ETX CD - Manual (Page 11)

3 Specifications
Kontron User's Guide ETX CD 11
System Memory
The ETX®-CD uses 200-pin DDR2 Small Outline-Dual Inline Memory Modules (SO-DIMMs). One socket is
available for a DDR2-533 or DDR2-667 module up to 2GB capacity.
Note: ETX®-CD equipped with the CeleronM423 is not able to drive memory modules faster than DDR2-533.
Serial Digital Video Output (SDVO): Intel 945GM
➤ Concurrent Operation of PCI Express Graphics with SDVO
➤ Supports appropriate external SDVO components (DVI, LVDS, TV-out)
PCI 32: Intel ICH7
➤ Parallel PCI Bus 32 bit 33 MHz
Enhanced Intelligent Drive Electronics (EIDE): Intel ICH7
➤ One PCI Bus Master IDE port
➤ Supports 2 IDE devices
➤ Ultra 33 Direct Memory Access (DMA) mode
➤ Programmed Input/Output (PIO) modes up to Mode 4 timing
➤ Multiword DMA Mode 0,1,2 with independent timing
Serial ATA: Intel ICH7
➤ 2 Channels Serial ATA
➤ SATA Spec. Rev. 1.0 up to 150 MB/s per channel
Universal Serial Bus: Intel ICH7
➤ 4 USB
➤ USB legacy keyboard support
➤ USB floppy, CD-ROM, Hard drive, and memory stick boot support
10/100MB Ethernet:: Intel ICH7
➤ Fully compatible with IEEE 802.3
Onboard video graphics array (VGA): Intel® 945GM:
➤ Intel® Gen 3.5 Graphics engine
➤ Dynamic Video Memory Technology (DVMT 3.0)
➤ Cathode ray tube (CRT) up do QXGA
➤ low voltage differential signaling (LVDS) liquid-crystal display (LCD) and SDVO
interfaces up to UXGA
➤ Supports DX 9.1