Invacare DLX - Manual (Page 32)

32
Detent Pin
Spreader Bar
FIGURE 4 - STORING/REPLACING THE
SPREADER BAR
RECLINER
R
E
C
L
I
N
E
R
REMOVING/INSTALLING THE
SPREADER BAR (FIGURE 4)
WARNING
Make sure detent pin of the spreader bar is
completely extended through the hole in the
handle BEFORE using the wheelchair.
2. Remove the twelve (12) mounting screws that
secure the back upholstery to the back canes.
3. Secure new back upholstery to back canes with
the existing twelve (12) mounting screws. Se-
curely tighten.
4. Reengage spreader bar. Refer to REMOVING/
INSTALLING THE SPREADER BAR in this proce-
dure of the manual.
Mounting
Screws
Back
Upholstery
Mounting
Screws
FIGURE 3 - REPLACING THE HEADREST/BACK
UPHOLSTERY
Back
Cane
Headrest
Upholstery
Headrest
Extension
Tube
NOTE: To remove and install the bottom two (2) mount-
ing screws of the back upholstery the wheelchair must
be partially folded. Refer to FOLDING AND UNFOLD-
ING THE WHEELCHAIR in the SAFETY/HANDLING
section of this manual.
Handle
Back Cane
Removing
1. Push in detent pin on one side of existing spreader
bar.
2. While holding existing spreader bar, pull handle
until the release pin is out of the handle of the
back cane.
3. Drop the spreader bar to one side.
4. Repeat STEPS 1-3 on opposite end of spreader
bar.
Installing
1. Push in detent pin on the handle of the new/existing
spreader bar.
2. Insert new/existing spreader bar into the handle of
the back cane.
3. Repeat STEPS 1-2 on opposite end of spreader bar.
PROCEDURE 8