Invacare JYMNI 9000 - Manual (Page 2)

9000 Series and Jymni™ Anti-tippers 2 Part No. 1058751
INSTALLING ANTI-TIPPERS (FIGURE 1)
1. Remove plug button (not shown) from end
of rear frame tubing and install anti-rattles if
not already installed.
2. Press the release buttons IN and insert the
anti-tippers with the anti-tipper wheels
pointing toward the ground/floor into the
rear frame tubing until the bottom release
button locks in place.
3. Measure the distance between the bottom
of the anti-tipper wheels and the ground/
floor.
NOTE: A 1-1/2 to 2-inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST
be maintained at all times.
4. ADJUSTABLE ANTI-TIPPERS ONLY - If the distance between the bottom of anti-tipper
wheels and the ground/floor is not 1/1/2 to 2-inches, adjust anti-tippers. Refer to ADJUSTING
THE ANTI-TIPPERS in this instruction sheet.
1-1/2 to 2-inch Clearance
FIGURE 2 - ADJUSTING THE
ANTI-TIPPERS
Release Buttons
ADJUSTING ANTI-TIPPERS (FIGURE 2)
NOTE: This procedure is for adjustable anti-tip-
pers only.
1. Press the release buttons on the
wheeled portion of the anti-tipper and
slide it up or down to achieve the 1-1/2
to 2-inch clearance.
2. Check to make sure that the release
buttons are fully engaged in adjustment
holes.
FIGURE 1 - INSTALLING THE
ANTI-TIPPERS
Anti-Tipper
Release Buttons
Rear Frame Tubing
Anti-Tipper Wheels
Anti-Rattle